概述: 自动搅拌车的操作程序我们来了解一下相关问题。 Automatic mixer safety operation procedures, let& 39;s learn about
自动搅拌车的操作程序我们来了解一下相关问题。
Automatic mixer safety operation procedures, let's learn about the relevant issues.
自动搅拌车是一种将水泥,砂骨料和水混合并混合成混凝土混合物的机器。它主要包括搅拌桶,进料和卸料机构,供水系统,原动机,传动装置,框架和支撑装置。由于只有合理的设备操作才能提高设备的性能,以下小编将介绍设备的操作程序。
An automatic mixer is a machine that mixes cement, sand, aggregate and water into a concrete mixture. It mainly includes mixing drum, feeding and discharging mechanism, water supply system, prime mover, transmission device, frame and supporting device. Since only safe and reasonable operation of the equipment can improve the performance of the equipment, the following section will introduce the safe operation procedures of the equipment.
1.在驾驶之前,您必须仔细检查自动搅拌车的状况,以确保车辆能够驾驶。
1. Before driving, you must carefully check the condition of the automatic mixer to ensure that the vehicle can drive safely.
2.当自动搅拌车停放在露天时,应在充电前翻转搅拌筒,并排干水和碎屑,以确保混凝土的质量。
2. When the automatic mixer truck is parked in the open air, the mixing drum should be turned over before charging, and the water and debris should be drained to ensure the quality of concrete.
3.运输混凝土时,确保倾斜槽牢固放置,防止其因松动而摆动,行人在行驶过程中可能受伤或影响其他车辆的正常运行,同时注意避免混凝土溢出和污染地面。
3. When transporting concrete, ensure that the inclined trough is firmly placed to prevent it from swinging due to looseness, and pedestrians may be injured or affect the normal operation of other vehicles in the process of driving. At the same time, attention should be paid to avoid concrete spilling and polluting the ground.
4.从自动搅拌车运输混凝土的时间不得超过搅拌站规定的时间。在运输混凝土的途中,搅拌筒不应长时间停止,以防止混凝土分离。驾驶员应始终注意具体情况,并在发现异常时通知主控室并申请。
4. The time for transporting concrete from the automatic mixer truck shall not exceed the time specified by the mixing plant. During the transportation of concrete, the mixing drum shall not be stopped for a long time to prevent concrete separation. The driver should always pay attention to the specific situation and inform the main control room and apply for treatment when abnormal conditions are found.
5.当混凝土安装在车内时,现场的停滞时间不得超过1小时。如果超时,应要求网站负责人及时处理。
5. When the concrete is installed in the vehicle, the site stagnation time shall not exceed 1 hour. In case of overtime, the person in charge of the website shall be required to deal with it in time.
6.当从自动搅拌车中非抽水时,从混凝土到水箱的时间不应超过2小时,并且必须在超过2小时后排出。当阴雨天气温度低时,不应超过2.5小时。
6. When not pumping water from the automatic mixer, the time from the concrete to the water tank shall not exceed 2 hours and must be discharged after more than 2 hours. When the temperature is low in rainy weather, it should not exceed 2.5 hours.
7.在排出混凝土之前,搅拌筒应以10-12 rpm的速度旋转1分钟然后排出。
7. Before discharging the concrete, the mixing drum should be rotated at a speed of 10-12 rpm for 1 minute and then discharged.
8.由于自动搅拌车的进料结束,进料口,卸料斗和卸料槽应冲洗并排干,以去除附着在阀体上的污垢和残留混凝土。保持车辆卫生。
8. Since the feeding of the automatic mixer is finished, the feed inlet, discharge hopper and discharge tank shall be flushed and drained to remove dirt and residual concrete attached to the valve body. Keep the vehicle clean.
任何机械设备在操作和使用过程中都需要一定的操作过程。在运行期间了解自动搅拌车的操作程序非常重要。我希望每个人都必须根据上述知识正确操作和使用它。
Any mechanical equipment in the operation and use process need a certain safety operation process. It is very important to know the safe operation procedure of the automatic mixer during operation. I hope everyone must operate and use it correctly according to the above knowledge.
对于自动搅拌车的操作规程介绍了解情况就是这样了,希望对你有帮助。
For the introduction of automatic mixer safety operating procedures, understand the situation is like this, hope to help you.