搅拌一体车跟其它车辆一样也是需要保养的，保养要从细节做起，平时在使用的过程中就需要细心，那具体需要注意哪些事项呢？

Like other vehicles, the mixer truck also needs maintenance. The maintenance should start from the details. Usually, you need to be careful in the process of use. What should you pay attention to?

1.一般新购买的搅拌车，在使用一两周后就需要紧固整车的螺丝，特别是连接副梁和底盘之间的“U型”螺栓，其次是减速机与罐体之间的螺栓，紧固时，拧紧力矩应达到300-350Nm。

1. Generally, newly purchased agitators need to tighten the screws of the whole vehicle after a week or two of use, especially the "U" bolts connecting the auxiliary beam and chassis, followed by the bolts between the reducer and the tank. When tightening, the tightening torque should reach 300-350Nm.

2.液压系统初次使用250小时后一定要更换高压抗磨液压油，以后每使用2500小时更换一次，但换油时间做多不得超过一年，换油的同时好更换散热器滤芯。

2. After the hydraulic system is used for 250 hours for the first time, the high-pressure anti-wear hydraulic oil must be replaced. After that, it must be replaced every 2500 hours, but the oil change time should not exceed one year. The radiator filter element should be replaced at the same time.

3.减速机初次使用250小时要更换重负荷齿轮油，以后每2500小时更换一次，但换油时间不得超过一年。

3. The heavy load gear oil shall be replaced after the reducer is used for 250 hours for the first time, and then every 2500 hours, but the oil change time shall not exceed one year.

4.正常使用过程中，当散热器真空表读数超过0.03MPa时，应立即更换液压油和滤芯。

4. During normal use, when the radiator vacuum gauge reading exceeds 0.03MPa, replace the hydraulic oil and filter element immediately.

5.散热器温控开关是自动控制风扇的运转和停止，请不要随意扳动。

5. The radiator temperature control switch automatically controls the operation and stop of the fan. Please do not pull it at will.

6.连接底盘和液压泵间的传动轴应每周加注锂基脂润滑油。

6. The transmission shaft connecting the chassis and the hydraulic pump shall be filled with lithium base grease every week.

7.搅拌一体车的搅拌罐每次卸料完毕都须进行内部清洗，以防罐内粘灰，少三个月进行一次清理。

7. The mixing tank of the mixer truck must be internally cleaned after each discharge to prevent ash sticking in the tank, which shall be cleaned at least once every three months.

8.罐体检查孔，就是“人孔”用于罐体内部维修的，要时，可打开放出罐内的预拌混凝土。

8. The tank inspection hole is the "manhole" used for the internal maintenance of the tank. When necessary, it can be opened to release the ready mixed concrete in the tank.

9.搅拌罐导轨与托轮之间接触面每周需要加涂锂基脂润滑油。

9. The contact surface between the guide rail and the supporting wheel of the mixing tank shall be coated with lithium based grease every week.

10.托轮每周需要加注锂基脂润滑油。

10. The supporting wheel shall be filled with lithium base grease every week.

11.卸油转轴每周加注锂基脂润滑油。

11. The oil unloading shaft shall be filled with lithium base grease every week.

12.搅拌一体车的操纵系统每周加注锂基脂润滑油，保证操纵灵活。

12. The control system of the mixer truck shall be filled with lithium base grease lubricating oil every week to ensure flexible operation.

以上搅拌车的12个事项要充分了解到，这样才能更好的在施工中顺利使用，您有什么问题没理解就来我们网站http://www.jfhntjbc.com咨询吧！

We should fully understand the above 12 items of mixer truck, so that it can be used smoothly in construction. If you have any questions, please come to our website http://www.jfhntjbc.com Consult!