您好,欢迎光临莱州聚峰机械有限公司网站! 主营自动搅拌车,搅拌一体车,自动上料搅拌车等各种规格的产品。

自动上料搅拌车生产厂家

点击拨打服务热线:4008791999

您的位置:首页 - 新闻中心 > 公司新闻

自上料搅拌车清洗土渣五种方式

发布时间:2022-10-10 来源:http://www.jfhntjbc.com/ 浏览量:0

概述:自上料搅拌车有时候会出现问题,是由于里面有很多的土渣没有清理干净,需要及时将内部的土渣清理出来,这样才能使它正常运行,接下来就教大
自上料搅拌车有时候会出现问题,是由于里面有很多的土渣没有清理干净,需要及时将内部的土渣清理出来,这样才能使它正常运行,接下来就教大家清理土渣的方法,在此五种方式。
Sometimes there are problems with the self feeding mixer, because a lot of soil residues are not cleaned up, so it is necessary to clean up the internal soil residues in time, so that it can operate normally. Next, we will teach you how to clean up the soil residues, and here we recommend five methods.
一般来说对于搅拌机在使用时候我们都会提前检查但是因为土渣在搅拌机的内部平时不太注意,但是只要我们稍微仔细看下就能发现这种情况所以我们再使用前都可以先检查这个问题把这种情况防患于未然。
Generally speaking, we will check the mixer in advance when it is used, but we don't pay much attention to the soil slag inside the mixer, but as long as we look carefully, we can find this situation, so we can check this problem before using it to prevent it.
1、准备好紧急驱动软管,将自上料搅拌车熄火,卸下液压马达上的高压油管接头。
1. Prepare the emergency drive hose, turn off the self feeding mixer truck, and remove the high-pressure oil pipe connector on the hydraulic motor.
2、将救援车熄火,将其液压马达的高压油管卸下,并与故障车上的对应接头用紧急驱动软管相连。
2. Turn off the rescue truck, remove the high-pressure oil pipe of its hydraulic motor, and connect it with the corresponding connector on the faulty truck with the emergency drive hose.
自上料搅拌车
3、发动救援车,将其操纵手柄拨出料位置,故障车内的混凝土即被排出。
3. Start the rescue truck and turn its handle to the discharge position, and the concrete in the faulty truck will be discharged.
4、紧急驱动完毕后,将驱动软管卸下,并恢复两车原状。
4. After the emergency drive is completed, remove the drive hose and restore the two vehicles to their original state.
5、还有一种简单点的方法就是在托轮和滚道之间放入木楔,控制搅拌筒的旋转,将发动机熄火,拆松液压马达的一根高压油管,搅拌筒可自由旋转,控制搅拌筒的旋转,使维修孔转到下部,然后打开维修孔,清理出筒内混凝土。混凝土排出完毕后,恢复搅拌车原状。
5. Another simple method is to put a wooden wedge between the supporting wheel and the raceway, control the rotation of the mixing cylinder, turn off the engine, loosen a high-pressure oil pipe of the hydraulic motor, the mixing cylinder can rotate freely, control the rotation of the mixing cylinder, turn the maintenance hole to the lower part, open the maintenance hole, and clean the concrete in the cylinder. After the concrete is discharged, the mixer truck shall be restored to its original state.
以上就是自上料搅拌车清洗土渣的方法,无论是选择哪种方法都要注意,更多的相关使用事情就来我们网站http://www.jfhntjbc.com进行咨询吧!
The above is the method of cleaning soil slag from the charging mixer truck. No matter which method you choose, you should pay attention to safety. More related use matters will come to our website http://www.jfhntjbc.com Consult!

截屏,微信识别二维码