概述: 自动上料混凝土搅拌车在出现故障的时候,需要及时将内部的混凝土清理出来,通常有两种方法清理: When the automatic loading c
When the automatic loading concrete mixer fails, the internal concrete needs to be cleaned out in time. Generally, there are two methods to clean up:
方法一:
Method 1
1. Prepare the emergency drive hose, turn off the automatic feeding concrete mixer, and remove the high-pressure oil pipe joint on the hydraulic motor.
2.将救援车熄火,将其液压马达的高压油管卸下,并与故障车上的对应接头用紧急驱动软管相连。
2. Turn off the fire of the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor, and connect it with the corresponding connector on the fault vehicle with the emergency drive hose.
3.发动救援车,将其操纵手柄拨出料位置,故障车内的混凝土即被排出。
3. Start the rescue vehicle, turn its control handle to the discharging position, and the concrete in the fault vehicle will be discharged.
4.紧急驱动完毕后,将驱动软管卸下,并恢复两车原状。
4. After the emergency drive, remove the drive hose and restore the original state of the two vehicles.
方法二:
Method 2
在托轮和滚道之间放入木楔,以控制搅拌筒的旋转,一定要注意;将发动机熄火,拆松液压马达的一根高压油管,搅拌筒可自由旋转,控制搅拌筒的旋转,使维修孔转到下部,然后打开维修孔,清理出筒内混凝土。此时一定要注意,混凝土排出完毕后,恢复自动上料混凝土搅拌车原状。
Put a wooden wedge between the supporting roller and the raceway to control the rotation of the mixing drum. Be sure to pay attention to safety. Turn off the engine and loosen a high-pressure oil pipe of the hydraulic motor. The mixing drum can rotate freely and control the rotation of the mixing drum to make the maintenance hole turn to the lower part, and then open the maintenance hole to clean out the concrete in the cylinder. At this time, attention must be paid to safety. After the discharge of concrete, the automatic loading concrete mixer shall be restored to its original state.
In general, most people will choose method one to solve the problem. When method one fails to solve the problem, they will choose method two. Hope the above methods are helpful to you. If you want to know more, please click our website: automatic loading concrete mixer http://www.jfhntjbc.com 。