自动搅拌车的运用与养护是休戚相关的,要懂得奇妙地运用自动搅拌车,才干省去很多不必要的费事。那么自动搅拌车使用时的维护事项有什么?小编为给您讲解下。
The use and maintenance of the automatic mixer are closely related. It is necessary to know how to use the automatic mixer wonderfully to save a lot of unnecessary trouble. What are the maintenance items of the automatic mixer when it is used? I will explain to you.
1、每次出车前应检查液压油位置,油位高出2~3㎝为宜。
1. Before each trip, check the hydraulic oil position, and the oil level should be 2~3cm higher.
2、整体泵应每月检查一次液压油系统油位,油位应到该螺栓纹口处。
2. The oil level of the hydraulic oil system of the integral pump shall be checked once a month, and the oil level shall reach the groove of the bolt.
3、有黄油嘴的地方应每周打一次黄油,保证正常润滑。另外拖轮和滚道结合面处应3~4天加一次黄油,保持正常。
3. Grease the places with grease fittings once a week to ensure normal lubrication. In addition, grease shall be added to the joint surface of tugboat and raceway once every 3-4 days to keep it normal.
4、整体泵(指没有减速机油箱的)应使用SAE15W~40发动机油。
4. SAE15W-40 engine oil shall be used for integral pump (referring to the pump without reducer oil tank).
5、后操纵手柄每次由搅拌变成卸料或由卸料变成搅拌都要在中间位置停顿一下,在搅拌筒停止转动后再执行下一动作。在手柄扳到极限位置时不能继续用力,防止油泵卡死。
5. Each time the rear joystick changes from mixing to discharging or from discharging to mixing, it should pause at the middle position, and then execute the next action after the mixing cylinder stops rotating. When the handle is pulled to the limit position, do not continue to exert force to prevent the oil pump from being stuck.
6、每次收工时要将搅拌筒内外洗干净,保证搅拌筒内无积快。如果在工地卸料时间超过2~3小时回来时也要将搅拌筒内清洗干净。
6. Clean the inside and outside of the mixing drum at the end of each work to ensure that there is no accumulation in the mixing drum. If the unloading time at the construction site exceeds 2-3 hours, the mixing drum shall also be cleaned.
7、洗车时应注意高压水流不能对准减速机法兰密封圈处冲洗,以免伤害润滑油脂。
7. When washing the vehicle, it shall be noted that the high-pressure water flow cannot be aligned with the flange sealing ring of the reducer to wash, so as to avoid damaging the lubricating grease.
8、使用一段时间,应检查进料斗密封皮的完好性,如磨损厉害须及时更换,否则易造成筒口或进料斗磨损。
8. After being used for a period of time, check the integrity of the sealing skin of the feed hopper. If it is severely worn, replace it in time, otherwise it is easy to cause wear of the barrel mouth or the feed hopper.
The concrete is easy to dry. During transportation, especially long-distance transportation, an automatic mixer is required, because the mixer can not only realize long-distance transportation, but also continuously stir the concrete during transportation. So pay more attention to us in this aspect http://www.jfhntjbc.com Learn more!